Blue Hawk SGY-PWA67 Guia De Inicio Rapido

BLUE HAWK is a registered
®
trademark of L.F., LLC. All
Rights Reserved.
ATTACH YOUR RECEIPT HERE
Serial Number
Questions, problems, missing parts? Before returning to your retailer, call our
customer service department at 1-877-888-8225, 8 a.m.- 8 p.m., EST, Monday -
Friday.
AB16205
PREPARATION
Before beginning assembly, installation or operation of product, make
sure all parts are present. Compare parts with package contents list. If
any part is missing or damaged, do not attempt to assemble, install or
operate the product.
•
Estimated Assembly Time: 5-10 minutes
INSTALLATION INSTRUCTIONS
1. Remove existing wand (not included) from spray gun (not included).
1.
2. Attach the M22 male coupler (A) to the spray gun.
2.
A
3. Attach the M22 female adapter (B) to the existing wand.
3.
B
CONFIGURATION OPTIONS
4. Attaching the M22 male coupler (A) to the spray gun and the M22
female adapter (B) to the existing wand allows for quick disconnect of
the wand from the spray gun.
4.
ITEM #0101646
EXTENSION WAND WITH
QUICK-CONNECT SET
MODEL #SGY-PWA67
Español p. 5
Purchase Date
1
A
B
3
PACKAGE CONTENTS
C
B
DESCRIPTION
PART
A M22 Male Coupler
B M22 Female Adapter
30 in. Wand
C
D Angled Extension
SAFETY INFORMATION
• When changing accessories, turn off pressure washer and water
supply and depressurize unit by squeezing the gun trigger until
all the water has drained from the hose and gun.
• Never point spray nozzles or guns at humans or animals.
• Never place any body part in the water stream.
• Serious injury can result from the high pressure discharge
produced by pressure washers.
• To prevent accidental discharge from the gun, always use the
trigger lock when you've finished spraying.
• Keep out of reach of children and never allow children to handle
equipment.
5. To extend the reach of your existing wand, attach the M22 male
coupler (A) to the spray gun, then attach the M22 adapter (B) to the
existing wand. Attach the 30 in. wand (C) to the spray gun, then
attach the existing wand to the 30 in. wand extension.
5.
B
6. To add an angle to your existing wand, attach the angled extension
(D) to the M22 male coupler (A) on the end of the spray gun.
6.
D
A
7. For an extended angled reach, add the M22 male coupler (A) to the
spray gun, then connect the 30 in. wand (C). Finally, connect the
angled extension (D) to the 30 in. wand.
7.
D C
NOTE: Up to 3 extension kits can be connected together, allowing for a
90 in. extension to the reach of your spray gun.
CARE AND MAINTENANCE
To promote longer life of accessories, run clean, fresh water through
them and turn off pressure washer and water supply. Depressurize by
squeezing the trigger until all the water has been drained from the unit.
Accessories are now safe to disconnect for storage in a cool, dark area.
If debris exists after disconnection, clean before storing.
A
D
QUANTITY
1
1
1
1
2
C A
A
Printed in China
BLUE HAWK is a registered
®
trademark of L.F., LLC. All
Rights Reserved.
4