TRENDnet TC-NT2 Manual De Instrucciones página 5

Optional Accessory TC-NTUF (Sold Separately)
IEEE 1394 (6-pin) / USB Cable
1. Connect one TC-NTUF to the remote port on the TC-NT2 transmitter. Connect
another TC-NTUF to the loopback port on the TC-NT2 remote terminator.
2. Connect one end of a USB or Firewire cable to the TC-NT2 remote transmitter.
Connect the other end of the USB or Firewire cable to the TC-NT2 transmitter.
3. Switch the power button on the TC-NT2 transmitter to the "On" position.
4. Press the auto (automatic) or test (manual) button.
1
TC-NT2
REMOTE
TERMINATOR
1
TC-NT2
REMOTE
TERMINATOR
Firewire
2
4
USB
2
4
4
1
TEST
POWER / TONE
3
OFF / ON
AUTO
TC-NT2
TRANSMITTER
1
TEST
POWER / TONE
3
OFF / ON
AUTO
TC-NT2
TRANSMITTER