Alarm Setting - LEXIBOOK WB400 Manual De Instrucciones

3. Use or
matches the sensor you want to receive information from. The data of the
corresponding remote sensor will be displayed in idle mode. The selected
channel must be the same as the one chosen for the remote sensor with the
channel selector. If the channels are different, the main unit will not be able
to receive the data sent by the sensor. The weather station will automatically
detect the new sensors.
4. Press to confirm your selection.
MODE
Note:
• If the sensor (or the main unit) is too close to other electrical devices,
interference may cause malfunction. You can change the channel on the
sensor and main unit as described above to improve the reception.
• It may take up to 3 minutes before the main unit displays the readings.
• After a few seconds of inactivity, the main unit will go back to normal mode.
• If the sensor is exposed to very low temperatures for an extended period of
time, the batteries may lose power, which may cause the transmission range to
be limited. High temperatures also reduce the battery performance.
Clock setting
1. In normal mode (idle screen), press
2. Press and hold
3. Use or
and adjust the next setting.
4. The setting sequence is displayed in the following order:
Hours Minutes
(Day/Month) or MD (Month/Day) display
Note: When the DST function is turned on,
5. Press to confirm your selection and go back to normal mode (idle
MODE
screen).
You can set the alarm to sound with a beep tone without the light display or 1 of
the 4 music themes with a light display.
1. In normal mode (idle screen), press
2. Use or
alarm is turned on.
3. Press and hold
8
to select the outdoor channel (
CLOCK AND DATE SETTING
until the hour digit starts flashing.
MODE
to increase or reduce the values, then press
Year Month

ALARM SETTING

to toggle between alarm on or off.
until the hour digit starts flashing.
MODE
,
once to go to the clock setting.
MODE
Day 24hr/12hr display
DST function On/Off.
is displayed in normal mode.
twice to go the alarm setting.
MODE
appears when the
or icons) that
to confirm
MODE
DM