HealthSmart 522-9814-1900 Instrucciones

Instructions
Adjustable Bath Seat
Item # 522-9814-1900
Assembly Instructions
1. Place the seat upside down on a flat surface.
Crisscross the seat leg assembly so that the center
flattened areas are flush. Insert a 1-1/2" screw
knob with a curved washer through both legs
into the bottom of the seat as shown in Fig. 1.
Hand tighten.
Note: Do not over tighten, as it could strip the
threads.
2. Place a curved washer on each of the 1-1/3"
screw knobs. Then insert the screws knobs
through the holes in the leg assembly in to the
bottom of the seat as shown in Fig. 2. Hand
tighten all screw knobs.
Note: Do not over tighten, as it could strip the
threads.
3. Adjust the extension legs in 1" increments to the
desired height, and lock the pins into place.
Caution: Make sure all screws are tightened
securely. For your safety, the four extension legs
must always be locked in the same height position.
All pins must be pushed completely through the
pinholes before using.
Note: If any parts are missing, do not return to the
place of purchase, call 800.622.4714.
Warning: Do not use if any parts appear to be loose
or damaged as personal injury may result.
Assembly Codes
1 – Support Legs (2)
2 – Seat (1)
a – 1-1/2" Screw Knobs (1)
b – 1-1/3" Screw Knobs (4)
c – Bent Washers (5)
Toll-Free Customer Care Help Line: 800.622.4714
Monday – Friday 8 a.m. to 6 p.m. EST
Fig. 1
c
c
Fig. 2
CAUTION
This product contains natural rubber latex, which
may cause allergic reactions.
1
a
c
1
2
b
c
c
2
Weight capacity: 325 lbs.
Manufactured for:
Briggs Medical Service Company
1931 Norman Drive
Waukegan, IL 60085
Made in China
#910-8714-1900 05/11
© 2011 Briggs Medical Service Company