ASROCK FM2A88M-HD+ R3.0 Manual De Instrucciones página 20

1. High Definition Audio supports Jack Sensing, but the panel wire on
2. If you use AC'97 audio panel, please install it to the front panel audio
System Panel Header
(9-pin PANEL1)
(see p.1 No. 12)
Connect the power switch, reset switch and system status indicator
on the chassis to this header according to the pin assignments below.
Note the positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may con-
figure the way to turn off your system using the power switch.
RESET (Reset Switch):
Connect to the reset switch on the chassis front panel. Press the reset
switch to restart the computer if the computer freezes and fails to per-
form a normal restart.
PLED (System Power LED):
Connect to the power status indicator on the chassis front panel. The
LED is on when the system is operating. The LED keeps blinking
when the sys-tem is in S3 sleep state. The LED is off when the system
is in S4 sleep state or powered off (S5).
18
All manuals and user guides at all-guides.com
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows ® 10 / 10 64-bit / / 8.1 / 8.1 64-bit / 8 / 8 64-bit / 7 / 7 64-
bit 64-bit OS: Go to the "FrontMic" Tab in the Realtek Control panel.
Adjust "Recording Volume".
PLED+
PLED-
PWRBTN#
GND
1
GND
RESET#
GND
HDLED-
HDLED+
This header accommodates
several system front panel
functions.