Ryobi Tek4 RP4011 Manual Del Operador página 4

MAINTENANCE
WARNING:
Always wear eye protection with side shields marked to comply with
ANSI Z87.1. Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
WARNING:
To avoid serious personal injury, always remove the battery pack
from the product when cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are
susceptible to damage from various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove dirt, dust,
oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken or destroy plastic which may result
in serious personal injury.
BATTERIES
This product will accept Ryobi 4 V lithium-ion batteries. Length of
service from each charging will depend on the type of work you are
doing. Lithium-ion batteries have been designed to provide maximum
trouble-free life. However, like all batteries, they will eventually wear out.
Do not disassemble battery pack and attempt to replace the batteries.
Handling of these batteries, especially when wearing rings and jewelry,
could result in a serious burn.
To obtain the longest possible battery life, we suggest the following:
 Remove the battery pack from the charger once it is fully charged
and ready for use.
For battery pack storage longer than 30 days:
 Store the battery pack where the temperature is below 80°F and
away from moisture.
 Store battery packs in a 30%-50% charged condition.
 Every six months of storage, charge the pack as normal.
BATTERY PACK REMOVAL AND PREPARATION FOR
RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with heavy-duty
adhesive tape. Do not attempt to destroy or disassemble battery
pack or remove any of its components. Lithium-ion batteries must
be recycled or disposed of properly. Also, never touch both terminals
with metal objects and/or body parts as short circuit may result.
Keep away from children. Failure to comply with these warnings
could result in fire and/or serious injury.
CALIFORNIA PROPOSITION 65
WARNING:
This product may contain chemicals, including lead, known to the
State of California to cause cancer, birth defects, or other reproduc-
tive harm. Wash hands after handling.
TROUBLESHOOTING
See Figure 12, page 14.
CAUSE
204 Calculation error
252 Temperature too high
253 Temperature too low
255 Received signal too
weak, time for a
measurement too long
256 Received signal too
strong
257 Faulty measurement,
too much background
light
258 Outside of the range
of measurement
Error Hardware error
LIMITED DEUX YEAR WARRANTY AND 90 DAY EXCHANGE POLICY
90-DAY EXCHANGE POLICY: During the first 90 days after date of purchasing
this product, you may either request service under this warranty or you may
exchange it by returning it with proof of purchase and all original equipment
packaged with the original product to the dealer from which it was purchased.
The replacement product will be covered by the limited warranty for the balance
of the deux year period from the date of the original purchase.
LIMITED DEUX YEAR WARRANTY. This product is warranted against all defects
in workmanship or materials for a period of deux years from the date of purchase.
The warranty on any accessories for this product, excluding batteries, is limited
to 90 days from the date the accessory is purchased. To obtain warranty service,
call Customer Service at 1-800-525-2579 for warranty return instructions. The
product must be properly packaged and returned with all equipment that was
included with the original product. When you request warranty service, you
must also present proof of purchase documentation, which includes the date
of purchase (for example, a receipt or a bill of sale). Defective products returned
within the warranty period will be repaired or replaced, at our option, free of
charge, within ninety (90) days or less. The cost of shipping the product to us
is your responsibility. This warranty only covers defects arising under normal
usage and does not cover any malfunction, failure or defects resulting from mis-
use, abuse, neglect, alteration, modification or unauthorized repairs. It applies
only to the original purchaser at retail, and may not be transferred. One World
Technologies, Inc. makes no warranties, representations or promises as to the
quality or performance of this product other than those specifically stated in this
warranty. Any implied warranties granted under state law, including warranties
of merchantability or fitness for a particular purpose, are limited to deux years
from the date of purchase. One World Technologies, Inc. is not responsible for
direct, indirect, or incidental damages Some states do not allow limitations on
how long an implied warranty lasts, or the exclusion or limitation of incidental
or consequential damages, so the above limitations and exclusions may not
apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
ONE WORLD TECHNOLOGIES, INC.
1428 Pearman Dairy Road, Anderson, SC 29625
Phone 1-800-525-2579
États-Unis, Téléphone 1-800-525-2579
USA, Teléfono 1-800-525-2579
4
OPERATION
CORRECTION
Repeat procedure
Let device cool down
Warm device up
Move closer to the target and take two
measurements; combine them using the
addition and subtraction feature.
Target a different surface and retake
measurement
Retake the measurement in lower light
conditions; target a different surface.
Select measurement distance within the
range of measurement
Should this message remain active after
switching the instrument off and on
several times, please contact Customer
Service
WARRANTY
www.ryobitools.com