Habitat Camus 915219 Manual De Instrucciones página 2

EN
This manual contains important information that should be kept for
future reference.
For domestic use only.
Self-assembly.
Warning! Keep children away from the assembly area. Leave the
plastic bags out their reach. The small parts pose a choking hazard.
Materials
Structure: chipboard oak veneer, clear matt lacquer. Ladder and
support: steel.
Assembly Instructions
In order not to lose components, do not throw the pack-aging before
completing the full assembly.
Before beginning assembly, identify all the components using the
manual.
This product must be assembled by an adult.
Plan to assemble the product as close as possible to where it will
be installed.
Assemble on a clean, flat surface.
Do not use an electric screwdriver.
The product cannot be assembled more than one time. Warning!
Before drilling, make sure that no pipes or cables will be present in
the drilling area. Fix the product to the wall to ensure its stability.
Use the type of screws and wall plugs for the supporting material.
With time, the bindings can lose their effectiveness. Regularly check
the tightening of screws. If necessary tighten.
Recommendations for use
This product is designed for indoor use only.
Do not climb the product.
Do not overload shelves.
Check the proper assembly before each use.
The wood-based products, particle board, painted, var-nished and / or
lacquers may emit an odor when opened. This smell disappears after
a few weeks if the room is properly ventilated.
Maintenance
Part(s) of wood
Remove dust regularly with a dry cloth.
Clean with a soft, damp cloth. Then wipe with a clean dry cloth.
Wipe up spills immediately with a clean, dry cloth.
To prevent scratching, do not use a sponge or recurrent grains
detergent.
Do not use abrasive products.
The use of special products for the wood is not neces-sary or
recommended.
Do not place the product near a heat source (radiator, fireplace ...)
nor a moisture source. Heat and humidity may damage the product.
In order not to damage the surface, it is recommended not to deposit
hot items Wet directly.
Clean with movements in the direction of the wood fibers.
Clear scratches with a cloth soaked in red polish.
Camus - 06/2021
Metal components
Remove dust regularly with a dry cloth.
Clean metal parts with a soft cloth dampened with neutral pH
detergent. Then wipe with a dry cloth to prevent spotting.
Clean chrome surfaces, stainless steel, brass or iron with
specialized products. Always carefully follow the instructions for use
accompanying maintenance prod-ucts.
Do not use solvent.
Do not oil the metal.
Do not use abrasives.
Keep the label with lot number, it may be useful in case of
BC
complaint.
If you have any comments or suggestions regarding this product,
assembly instructions or service received, please enquire at your
nearest store or contact us on our website at: www.habitat.eu or
write to this address: HABITAT, 70 AVENUE VICTOR HUGO, 93300
AUBERVILLIERS FRANCE.
1