GameFactor MG600 Guía Rápida página 9

INSTALLATION
3. Connect the Displayport or HDMI cable of your
computer to the corresponding port on the back of
the monitor (1).
4. Connect the power supply cable to the monitor.
5. On: Press universal button (4) to turn on your
monitor.
6. Off: Press universal button (4) to turn off your
monitor.
7. When the monitor is operating under normal
conditions, the LED indicator light will be green
(or blue); If the monitor is in saving mode, the LED
indicator light will be red. When the power indicator
is off it means that the monitor is in power off
mode. Please disconnect the power cable when the
monitor is not being used.
INSTRUCTIONS FOR USE
1. Turn on your monitor (your monitor must be receiving a
signal to enter the setup menu).
2. Press the universal button (4) located on the back of
your monitor.
3. Press the universal button (4) up and down to switch
between the options shown.
4. To select the desired option to configure, select it with
the universal button (4) and navigate through the
menu with the button.
5. If you wish to go back from the previously selected
submenu, press the universal button (4).
Settings Menu
Press Menu in the main menu, select MENU.
Press up and down to change the main menu image for
changing settings.
Press Menu to change submenu settings, and press up and
down in the menu.
Press up and down to adjust the settings.
Press AUTO to return to the main menu.