Bushnell 119986C Manual De Instrucciones página 6

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an output on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Shielded interface cable must be used with the
equipment in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC Rules.
Specifications and designs are subject to change without
any notice or obligation on the part of the manufacturer.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation. Please
note that changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
10
This equipment contains electric and/or electronic
parts and must therefore not be disposed of as normal
household waste. Instead, it should be disposed at the
respective collection points for recycling provided by the
communities. For you, this is free of charge.
If the equipment contains exchangeable (rechargeable)
batteries, these too must be removed before and, if
necessary, in turn be disposed of according to the relevant
regulations (see also the respective comments in this
unit's instructions).
Further information about the subject is available at your
community administration, your local waste collection
company, or in the store where you purchased this
equipment.
For further questions or additional information please contact:
Bushnell Outdoor Products
9200 Cody, Overland Park, Kansas 66214
(800) 423-3537 • www.bushnell.com
©2021 Bushnell Outdoor Products
11