Publicidad
Idiomas disponibles
Idiomas disponibles
PINS
INSTRUCTIONS
The installation of this switch must always be carried out by an authorized installer.
Flush-mounted DIN 49073 55 mm boxes will be used (minimum depth 40 mm).
Surface-mounted, consult your supply warehouse.
Easy to assemble it is recommended rigid wire HO 7V/1,5 mm2 be used.
Connections according to schematic located on the rear cover of the appliance.
SETTING THE TIME
Rotate the dial in the direction of the arrows, until the current time is made to
coincide with the marker.
PROGRAMMING
Shift all the pins upwards that corresponding to the desired connection times.
Minimum operation time:
ILUMATID D (Daily)
ILUMATIC S (Weekly)
MANUAL CONTROL
Automatic operation:
- Bottom switch to position "auto"
- Cradles outward connection on terminal 2.
- Cradles inward connection on terminal 1.
Permanently OFF: Bottom switch to position "0"
Permanently ON: Bottom switch to position "I"
CONNECTION: Connection scheme
TECHNICAL SPECIFICATIONS
Power supply:
Switching capacity:
Own consumption:
Maximum recommended load:
Type of dial:
Installation:
Operating temperature :
Type of Protection:
DIMENSIONS
FLUSH MOUNTING TIME SWITCH
INDEX
24
30 minutes switching time
1h 45 min. switching time
1
2
81
ORBIS TECNOLOGÍA ELÉCTRICA, S.A.
Lérida, 61
Teléfono:+ 34 91 5672277;
E-mail: info@ orbis.es
DIAL
0
auto
M
~
3
4
5
L
N
230 V~ 50 Hz
10 (4) A, 250 V~
1,6 VA
approx. 2200 W
Daily: 48 pins
Weekly: 96 pins
Flush mounting in universal box.
60 ºC
IP20
E–28020 MADRID
Fax:+34 91 5714006
http://www.orbis.es
ILUMATIC
MANUAL
OVERRIDE
31.5
17.5
A016.16.57244
Publicidad
