Uline H-1713 Manual Del Usuario página 5

DISPLAY – MOUNTING AND INSTALLATION CONTINUED
SETUP
SETTING SOUND TONE AND VOLUME
Use a mini flathead screwdriver to change the tone and
volume switches on back of the display. (See Figure 12)
Set the sound tone with switches 1-2:
• No sound: 1-OFF, 2-OFF
• Single tone: 1-OFF, 2-ON
• Double tone: 1-ON, 2-OFF
• Triple tone: 1-ON, 2-ON
Set the volume with switches 3-4:
• Low volume: 3-OFF, 4-OFF
• Medium volume: 3-ON, 4-OFF
(recommended in most cases)
• High volume: 3-OFF, 4-ON
• Highest volume: 3-ON, 4-ON
DISPLAY START-UP
The display shows a number of messages on start-up once
it is plugged in. (See Figure 13)
Display shows:
• Program version: "P-", then number
• TOM-Net address: 'ad", then 51 or 21
• Last number displayed when power was disconnected:
Number, ("00" if first-time start-up.)
• Error message if display is set as a duplicate master:
"Ed"
PAGE 5 OF 20
Figure 12
Figure 13
OPTIONAL DISPLAY SETUP
To enter setup options, make sure display is unplugged.
Hold down (+) on the wireless push button and plug the
display back in. Release (+) when display shows "UP."
1. Set display update delay:
• Display shows "UP" followed by the current delay time in
seconds, (ex. "00"). Press (+) on the wireless push button
to increase the delay one second at a time.
• After three seconds without pushing the button, the set
display sleep time "SL" appears.
2. Set display sleep time:
• Display shows "SL" followed by the current setting in
minutes. (The display shuts off after a set period of time
with no button pushes.) Press (+) on the wireless push
button to increase the delay before the display goes
into sleep mode one minute at a time.
• After three seconds without pushing the button, the set
display flashes and "FL" appears.
3. Set display flashes when number changes:
• Display shows "FL" followed by the current setting
showing number of flashes. Press (+) on the wireless
push button to increase the number of times the display
will flash when the number changes one flash at a time.
4. After three seconds without pushing the button, the
display shows "CS" and saves new settings to memory.
Delay Time (seconds)
1
Sleep Time (seconds)
2
Number of Flashes (when changing)
3
4
INSTALLING ADDITIONAL DISPLAYS
• See instructions included with H-2769 or H-4665.
(See Figure 14)
Range: 00–29
Range: 00–99
Range: 00–09
Figure 14
0421 IH-1713