Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WALL MOUNTING
1.
Remove faceplate and back plate and set aside.
2. Connect 20-inch jumper leads to AC input leads in
J-Box. Fasten J-Box bracket to J-Box. Use black wire
for 120V. Use orange or red wire for 347V. White wire
is common. In some cases, not all lead wires will be
used. Cap off unused wire.
3. Remove necessary knockouts and fasten back plate
to J-Box cover.
4. Snap housing on to back plate.
5. Connect and trim input lead. Slide through the hole
in the back plate and connect to supply leads in
J-Box.
6. Connect battery only after continuous AC power
can be provided to the unit.
7.
Secure face plate(s) to housing.
PAGE 2 OF 6
INSTALLATION
WIRING DIAGRAM
Transformer
Red (347V)
Black (120V)
White (Common)
1-800-295-5510
CEILING MOUNTING
1.
Remove faceplate and set aside.
2. Connect 20-inch jumper leads to AC input leads in
J-box. Fasten J-Box bracket to J-Box. Use black wire
for 120V. Use orange or red wire for 347V. White wire
is common. In some cases, not all lead wires will be
used. Cap off unused wire.
3. Fasten canopy to J-Box bracket.
4. Remove canopy hole cover on the top and snap
housing to canopy.
5. Connect and trim input lead. Slide through the
canopy and connect to supply leads in the J-Box.
6. Connect battery only after continuous AC power
can be provided to the unit.
7.
Secure face plate(s) to housing.
PCB/LED Board
uline.com
Test
Button
Ready
Light
Battery
0621 IH-7273
Publicidad
Tabla de contenido
