Uline H-6215 Guia De Inicio Rapido página 2

Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
PAGE 2 OF 6
INSTRUCTIONS FOR UNIT ASSEMBLY
1.
Shelf
Support
2. Slide post through underside of shelf until shelf slides firmly
3. Stand unit upright. Gently tap shelf down to secure it.
4. Determine the height of the bottom basket and snap on the shelf
5. Repeat step 4 for the remaining baskets.
6. Snap shelf supports onto the top groove of the posts. Slide the
1-800-295-5510
Start with the lowest shelf. Snap the interlocking pieces of a shelf
support (wide end down) around the post at the lowest groove
where shelf is to be located. Slide the support up or down until it
snaps onto the groove. Add a shelf support to the same place on
the remaining posts. (See Figure 3)
NOTE: NSF requires food service applications to keep the
lowest shelf at least 6" above the floor.
over supports. (See Figure 4)
(See Figure 5)
supports. The back shelf supports should be 4 grooves above the
front shelf supports. Then, add and secure the basket.
(See Figure 6)
shelf onto the supports. Tap shelf to secure.
(See Figure 7)
uline.com
0221 IH-6215