Kohler K-10540 Guia De Instalacion página 4

Wall Plate
1. Mark and Drill the Pilot Holes
NOTE: There is no provision for later adjustment if the resulting
pilot holes are not level.
Mark the holes on the finished surface for each wall plate. Use
the template on the back of the shipping carton to assist you OR
hold the grab bar assembly against the desired location to mark
the holes.
Confirm the marked holes are at the desired location.
CAUTION: Risk of property damage. Apply light, even pressure
when drilling through tile. Drill a clearance hole through the tile
and its backing only. Use a 3/16" or a #12 drill bit.
Select a drill bit appropriate for the wall material you will be
drilling through.
Carefully drill a hole at all marked hole locations.
2. Install the Grab Bar
Apply silicone sealant into the drilled holes (recommended).
Align the holes of the wall plates with the drilled holes on the
wall.
Secure the wall plate to the finished surface with the screws
provided. Do not overtighten.
Slide the escutcheons on the grab bar assembly over the wall
plates. Press into place.
1051224-2-B
Escutcheons
Screws
4 Kohler Co.