FMI Products GA6050 Instructivo Para La Instalación página 2

5. Slide the adjustable outer-hood sections
into the center section. Stop when edge
of center-hood section is even with tape
(see Figure 4).
6. Place pieces of tape across adjustable
outer-hood sections and center-hood sec-
tion to hold in place.
IMPORTANT: You must remove tape before
operating your fireplace.
Edge of Center-
Hood section
Figure 4 - Adjust Outer-Hood Section
INSTALLING HOOD TO MASONRY
FIREPLACE
Follow the instructions below that best
describes your fireplace .
1. Loosen clamps that hold glass door frame
to fireplace. Slide the mounting brackets
behind the glass door frame (see Figure
5). Place brackets near ends of horizontal
glass door frame. Note: If frame is too tall,
the bottom of mounting bracket will not
slide under lintel (top) of fireplace. If so,
cut mounting bracket off at point "B" (see
Figure 6). Slide mounting bracket into glass
door frame (see Figure 7).
2. Tighten glass door lintel clamps. This will
secure the mounting brackets.
3. Slide the hood over the mounting brackets
(see Figure 8).
Mounting
Bracket
Figure 5 - Placement of Mounting Bracket
2
Figure 7- Mounting Bracket for Tall Frame
MASONRY WITHOUT GLASS DOORS
1. Tape the mounting brackets near the ends
of the fireplace opening. Make sure to posi-
tion brackets as shown in Figure 9.
2. Mark screw locations on fireplace lintel
through the slots on bottom of each mount-
ing bracket.
Mounting
Glass
Bracket
Door
Frame
Figure 9 - Positioning Brackets for
Masonry Fireplace without Glass Doors
www.fmiproducts.com
A
B
Figure 6 - Mounting Bracket
Mounting
Bracket
Figure 8- Hood Placement
Bottom of
Mounting
Bracket
Glass
Door
Frame
Hood
Mounting
Bracket
Lintel
Masonry
Screw
100448-01F