Korenix JETCON 2401 Serie Guía De Instalación Rápida página 3

Connecting the Optical Fiber
The Fiber Optical link architecture supports PTP and SFR
mode for different purposes.
1. PTP Mode (Peer to Peer)
The PTP (Peer to Peer) mode provides connection between
2 nodes. When working on this mode, JetCon 2401
can transmit data and receive it at same time, which
means JetCon 2401 is working at full duplex mode.
2. SFR Mode (Serial Fiber Ring)
To extend the transmission distance and to save
the fiber cable cost, JetCon 2401 can link to each
other as a ring architecture, in this mode
JetCon 2401 only provides half duplex
transmission and all of data communication is
controlled by the host device. The maximum of
communication nodes can up to 20.
The table below illustrates fiber transceiverspecifications
Modul Fiber (um) Connecter Wavelength(um)
JetCon Multi-mode
ST 820nm
2401-m 50~62.5/125
JetCon Single-mode
ST 1310nm
2401-S 8~10/125
TxPwr(Min):Minimum Launch Power
RxPwr(Min):Maximum Receive Sensitivity
Link Budget=Minimum Launch Power -Maximum Receive Sensitivity
Note: To ensure your fiber converter transmission/receiving of data between the 2 nodes, the
attenuation of the optical fiber cable should be smaller than the fiber converter's Link Budget.
JetCon 2401 DIP Switch Setting
Function
RS-422/4 wires (Default)
RS-485/4 wires
RS-485/2 wires
RS-232
PTP Mode
RS232 RS422/485
SFR Mode
Half Duplex
JetCon 2401
RS422/485
RS232/422/485
TXPwr TxPwr RxPwr RxPwr
LinkBudg(dBm) Distance(km)
(Min) (Max) (Min) (Max)
-12dBm -9dBm -28dBm N/A 16dBm
-9dBm -8dBm -27dBm N/A 18dBm
TxPwr(Max):Maximum Launch Power
RxPwr(Max):Minimum Receive Sensitivity
DIP Switch 1 DIP Switch 2
OFF (Default) OFF (Default)
OFF OFF
OFF ON
ON OFF
Function
120 Ohm Terminator (RX)
120 Ohm Terminator (TX)
Point to Point /Serial Ring
Note: After adjusting the DIP-switch, please reboot the unit to activate the new settings.
Dimensions

24.7mm(H) x 96mm (W) x 99mm (L) with DIN
Regulatory Approvals

Safety : CE/EN60950
 EMI: FCC Class B, CE/EN55022,
CE/EN61000-3-2,CE/EN61000-3-3

EMS: EN61000-4-2 ESD, Level 3,
Criterion performance A
RS422/485
EN61000-4-3 RS, Level 3,
Criterion performance A
EN61000-4-4 EFT, Level 3,
Criterion performance A
EN61000-4-5 Surge, Level 3,
Criterion performance A
EN61000-4-6 CS, Level 3,
5KM
Criterion performance A
40km Korenix Customer Service
KoreCARE is Korenix Technology's global service center, where our professional staffs are
ready to answer your questions at any time.
Email of Korenix global service center: KoreCARE@korenix.com
DIP Switch Switch position
Switch 3 Off (Disable)/On (Enable), Default off
Switch 4 Off (Disable)/On (Enable), Default off
Switch 5 Off (PTP)/On (SFR ), Default off (PTP)
RX TX
2401
Serial to Fiber Media Converter
PWR
TX
RX
Ring
RS-422/485 RS-232 12-48V