Installation - Glacier bay F51AC074CP Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old faucet.
□
Clean off the mounting surface.
□
Ensure the gasket (L) is on the bottom of the new
faucet (A).
□
Place the faucet (A) through the mounting holes
in the sink.
□
Secure the faucet (A) to the sink using the
mounting nuts (C) provided.
NOTE: If the sink is uneven, use silicone under the
gasket (N).
C
2
Preparing the pop-up assembly
□
Insert the drain assembly (E) and rubber washer
(D) into the sink.
□
Secure the drain assembly (E) in place under the
sink using the large rubber washer (F) and lock
nut (G).
□
Opening for ball rod must face towards rear of
sink.
A
F
L
G
4
D
E
1
2
3