COMPLETION OF USE
• Press the ON/OFF switch (6) to position (0) to turn off the appliance.
• Wind the power cable on the hooks (4) (9) provided, as shown in
Figure 3.
• You can hang the appliance using the hole (3) on the handle.
INSTALLATION AND REMOVAL OF THE FILTER UNIT/CONTAINER (11)
This operation must be performed with the appliance turned off and the plug
removed from the wall socket.
After each use, or when, during use, the container appears to be about 50-60%
full, it is a good idea to empty it to prevent loss of suction power.
• Press the release button (10) towards the brush attachment and simultaneously pull
(11c) (Fig. 5).
To install, proceed as follows:
and then pressing on the upper part until it is correctly locked
Fig. 4
WARNING!
the appliance.
ENGLISH
Fig. 5
4
9
Fig. 4
Fig. 3