Polygroup SUMMER WAVES Manual Del Usuario página 5

7. Insert the Elbows into the top Horizontal Beam.
9. Continue to install the Left Board and Right Board.
11. Install the assembled backboard to the Vertical Beams.
Top Horizontal Beam: slot the Elbows onto the Vertical Beams
Bottom Horizontal Beam: snap the Beam Connectors onto the Vertical Beams
Loosen and reorient the Frame Clamps to refit the backboard if necessary.
NOTE: Do NOT lean over, climb on or shake the Beams or the Hoop.
It may cause damage to the Beams or Clamps, or injure the user.
Right Board
Left Board
OWNER'S MANUAL
8. Snap the Middle Board onto the Horizontal Beams. Make sure to align the
triangles on the Board to the vertical Printed Lines on both the Horizontal
Beams.
Top Horizontal
Beam
Bottom Horizontal
Beam
Middle Board
10. Install the Basketball Hoop onto the Middle Board by slotting in:
a. First the two bottom snaps.
b. Then the two top snaps.
NOTE: The Hoop will fall off if too much force is applied. This is a
safety design to avoid users hanging on the Hoop. Simply
reattach the Hoop if it comes off.
Printed Line on the
Top Horizontal Beam
Align the triangle to
the Printed Line
b
a
5