Power Supply - habitat et jardin Mini Comfort 1436 103460 Manual Del Usuario

1.4 Power Supply

Before connecting the power supply, make sure that the power supply matches the rated
power supply of the product.
Cable Selection of the Protection Device
Residual-current circuit breaker
Breaker
Rated residual leakage current
Power Cord（MM2)
Note: The above data is adapted to power cord ≤ 10m. If power cord is＞10m, wire diameter
must be increased. The signal cable can be extended to 50m at most.
Pay attention:
Please ensure the safety of
the power plug.
Otherwise, it could cause
electric shock or fire.
After all connections are complete and checked, perform the following steps:
1) The user should start the water pump first to ensure no water leakage in the water pipe
system; then set the thermostat at the appropriate temperature after power on.
2) In order to protect the machine, it has a delayed start function, after start up, the water
pump start, next fan runs, and the compressor will start up automatically after about 3
minutes
3) Check if there is any abnormal noise when running
Model
Fuse
※ Above data is subject to modification without notice.
Do not disconnect the power
supply while the machine is
running
Otherwise, it could cause an
electric shock or fire.
1436_103460 1436_103459 1436_103283
4.5
30
4.5
3×1.5
6
4.5 4.5
30 30
4.5 4.5
3×1.5 3×1.5
Do not use damaged or
substandard wires.
Otherwise, it could cause
an electric shock or fire.