Disclaimer; Safety; Operators; Service Technicians - Ranpak Geami WrapPak HV Manual Del Usuario

Geami WrapPak HV
PREFACE
i
This operator manual is made in the
original language.
This operator manual is intended for the operator of this
converter.
This operator manual belongs with the
i
converter. A copy should be kept with
the converter at all times.
In the event of the converter being transferred, all
documentation must be transferred with the converter.

Disclaimer

The manufacturer and its authorized distributor are not
liable for any accidents or damages resulting from the failure
to comply with warnings or instructions depicted on this
converter or contained in this operator manual, including:
- Improper use or maintenance
- Use for applications or under conditions other than those
outlined in this operator manual
- Use of unauthorized parts
- Repairs or modifications made without the permission of
the manufacturer
- Unauthorized alterations to the converter such as:
a) Alterations to the control system
b) Welding, mechanical treatments etc.
c) Extensions to the converter or the control system
The manufacturer and its authorized distributor are not liable
for:
- Indirect damages caused by errors or malfunctions
of the converter (e.g. damages to products, company
interruptions, delays, etc.).

SAFETY

This converter has been designed for safe use in conformance
with the application, conditions and rules described in this
operator manual. Anyone that works with or on this converter
must read the operator manual and follow the instructions
carefully.

Operators

Only those who read and understand the Sections "Safety"
and "Operator Instructions" should operate the converter.
Special training is not required.
Operator tasks include:
• Loading and feeding the paper rolls
• Operating the converter
• Weekly maintenance (see section 3.8)
◦ Remove paper scraps
◦ Remove excessive paper dust

Service technicians

Only service technicians employed by Ranpak or a Ranpak
distributor who are in possession of a certificate issued by
Ranpak service department are permitted to conduct service
on the converter. For these individuals, a separate service
manual is available.
Geami WrapPak HV Operator Manual - EN
®

Rules of Safety

• Safety devices are not allowed to be switched off or
removed
• Do not remove or cover warning labels
• Do not reach inside the converter
• Keep the working area clean and free of obstacles
• Unplug converter and gather all loose cords before
moving the converter
• Pay attention when using hand tools such as knives,
scissors etc, due to the risk of cutting
• Ensure that:
◦ cords cannot be damaged
◦ the converter is acclimatised when taken from a cold
to a warm area.
◦ the working area is sufficiently lit
◦ the working area is sufficiently ventilated
• Do not use cable reels. When using an extension cable,
note that the diameter must be at least 1,5 mm2 (14AWG)
with a maximum length of 10 m (33 ft).
• Plug the converter always into a grounding-type wall
socket
• Pay attention to ergonomic factors such as lifting,
bending, reaching, etc. during work on the converter

Improper Use

The following applications or acts are not suitable for the
converter, and constitute improper use of the converter:
• Use of materials other than those produced by Ranpak
and intended for use in the converter
• Use outside or in a humid area
• Use in areas subject to an explosion hazard
• Washing or cleaning the converter with excessive
quantities of water
• Standing on the converter
• Placing objects against or on top of the converter
• Moving the converter while it is functioning or connected
to the AC power supply.

Work Area

In order to operate the converter, you need a 1 meter (3 foot)
wide, open work area in front of the converter. From this
space, all operating actions can be carried out.

Converter Warnings

The warnings attached to the converter must remain visible
and legible at all times. Ask your distributor to replace them
when necessary. Do not block or cover any of the warnings.
Further information on the labels is included in Section 4
"Converter Labels"
EN
i