First activate the batteries inside the outdoor sensor,
then inside the temperature station.
Note: Remove all packaging material from the product.
Note: Before initial use, remove the protective film from the
LC display.
317485_1904_aur_Funk-Temperaturstation_content_US.indd 21
Before initial use
General information
When choosing where to position the product,
make sure that it is not exposed to direct sunlight, vibration, dust,
heat, cold or moisture. Do not place the product near heat
sources, e.g. radiators, to prevent product damage.
Please make sure that nearby devices do not use the same
frequency of 433 MHz. These types of devices may interfere
with the radio connection.
Do not place the product next to or on metal plates. Otherwise
the quality of radio wave transmission may be reduced.
US-EN
21
27.09.19 14:02