Safety Note - Sweet Protection KNEE PADS Manual De Usuario

Zones of protection: The areas the protectors are to be used for are listed
in capital letters. E for elbow and forearm; H for hip; K for knee and upper
tibia; L for leg below protector „K"; S for shoulder; K+L for knee, upper
and middle tibia.
Size of area to be protected: Type A = protectors of smaller dimensions;
Type B = protectors of larger dimensions.
The table below shows the permitted residual force values of the two levels
of protection according to the standard. Note: The standard refers to two
levels of protection. Level 1 for protectors designed to give protection
whilst having low ergonomic penalties; Level 2 for protectors providing
an increased protection. There may be weight and restriction penalties
associated with level 2 protection.
Total
Level average
value
1 ≤ 35 kN
2 ≤ 20 kN
PROTECTIVE EFFECT
When used and aligned correctly, the protector offers a certain amount
of protection against blunt trauma. Additionally, it can reduce or prevent
injuries such as abrasions and bruises in the area which it covers. Be aware
that no protector can offer full protection against injury!
ATTENTION
The protector provides, assuming correct use and alignment, a certain
amount of protection, but cannot completely protect from injury. The
protectors must be correctly aligned in the pockets provided. Please note
the labelling on the protectors.

SAFETY NOTE

The protectors must be corrected aligned in the pockets provided. Please
note the labelling on the protectors. The protective effect of the protectors
may be reduced by temperatures lower than -10°C. The protectors must
be regularly checked for visible damage, and shall be replaced after
being exposed to an severe impact. Do not make any modifications to the
protector. All retention straps must be securely fastened. Alterations or
incorrect use may significantly reduce their protective effect.
WARNING!
The end user should carefully read the instruction before using the
product (PPE).
Individual
value
area A
≤ 35 kN
≤ 20 kN
5
Individual
values
areas B + C
≤ 50 kN
≤ 30 kN