Battery Installation - GENWEC GW03 24 04 01 Manual De Instrucciones

BATTERY INSTALLATION

1. Open the cover of the battery box and put 4 x LR20 batteries correctly according "+" "-", and pull
back the cover.
2.
If there is a roll of paper towel in the dispenser, remove it before install the batteries.
DC Power supply (not included)
This dispenser introduces automatic power supply switch mode.
When DC transformer works, batteries do not. While DC transformer stops working, batteries start to
work automatically.
Please make sure DC transformer is well connected with appliance receptacle (see Figure 3).
Notes:
1. The dispenser will not work if install the batteries improperly.
2. To avoid breaking the dispenser, do not mix different kind of batteries to use.
3. When the dispenser is low battery, the indicator will flash one time per second. The dispenser can still
work but should replace he batteries. When the indicator flashes twice per second, it will stop working,
must replace the batteries.
LNSTALLATION OF ROLL PAPER TOWEL
Follow Step 1 and 2 to install the roll paper towel.
1. Pull the paper holder wheels from both sides slightly and pull a new roll of paper towel into it.
2. On hand lifts the transfer bar, the other one pulls the paper towel out between the transfer bar and
the rubber wheel (the distance from paper margin to rubber wheel is about 30mm), pull down the
transfer bar and close the cover.
Battery cover
Figure 3