Safety Recommendations - LOTRONIC LTC Audio MFA1200USB-BT Manual De Instrucciones

SAFETY RECOMMENDATIONS

• Before using the device, please check it for any possible damages. In case of damage do not operate it.
Unplug the UNIT if you do not use it for a certain time.
•
• Do not expose the unit to mechanical stress and humidity.
Ensure sufficient ventilation around the unit. Do not cover the device and protect it from direct solar
•
radiation.
Clean the device with a dry and soft cloth only.
•
• Caution! Should the device itself get damaged, please let the repair to the manufacturer or to a qualified
service agent.
• The unit must be connected to an earthed mains outlet only.
• Keep out of the reach of children
• DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
Front panel
POWER: Press this button to power ON or OFF the unit
SD: Connect your SD card here
USB: Connect your USB flash drive here
Treble: Turn this knob to adjust the treble of main output
Bass: Turn this knob to adjust the bass of main output
Balance: Turn this knob to adjust the balance of main output.
MIC VOL: Use this knob to adjust the microphone volume
MIC1 & MIC2: Connect your microphones here
Input: Press this button to switch among all the inputs.
Play/Pause: Press this button to play the signal from USB/SD, Bluetooth. Press again to pause
IR: Infrared sensor to receive the signal from the remote control
Previous: Press this button to go back to the beginning of the current track or move to the previous track or move
to previous station.
Next: Press this button to move to the next track or move to next station.
Master Volume: Use this knob to control the master volume.
OPERATION
Select a central location for the amplifier.
Connect the speaker wires (red & black) to the + and – terminals on the rear panel of the amplifier.
Connect the audio signal to the relevant sockets with the correct polarity.
©LOTRONIC 2016
GB
MFA1200USB-BT 2