Tripp-Lite T013-001-POE El Manual Del Propietario página 4

Continuity Testing
When a connection is established between
one end of the cable to the other, the Pin
LEDs will flash in succession to indicate the
pins for which a connection is found (see the
bullets below for pin listings). Pins that do not
illuminate for a cable/connector are open.
• RJ45 (UTP) – Pins 1 through 8 should be
• RJ45 (STP) – Pins 1 through 8 and the
• RJ11 – RJ11 cables can be 2-wire, 4-wire,
Open Connection
If wires in a cable are not connected from
one end to the other, the Pin LEDs for those
wires will not illuminate on either the Main or
Remote Testers. If only one wire is connected,
none of the Pin LEDs on the Main and Remote
testers will illuminate.
16-08-515-933624.indb 4
connected
S/G pin should be connected
or 6-wire. 2-wire RJ11 cables use pins 3
and 4; 4-wire cables use pins 2-5; and
6-wire cables use pins 1-6.
4
9/20/2016 9:44:09 AM