Conformity To Safety Standards - Axion STIM-PRO I-2000 Manual

The device must be subjected to safety checks and
maintenance by authorized technicians before use and
each re-use, but at least every 24 months.
Please consult your distributor if there are any problems
with device and accessories.
The manual must always be carried with the device.
MALFUNCTIONS
Should any malfunctions occur while using your device, check
the following points. If none of these can solve the problem,
please contact the customer service.
Check whether the cables are correctly connected to the
device.
The display does not turn on? Change the battery.
Check the cables for possible damage. The device may only
be used when subjected to a load.
There is no stimulation current? Check if the electrodes are
connected to the same channel correctly and if the intensity is
high enough.

CONFORMITY TO SAFETY STANDARDS

The STIM-PRO I-2000 device is in compliance with the
EN 60601-1-2:2007 and 60601-1:2006 safety standards.
STIM-PRO I-2000
EN
27