Edelbrock ELITE II Serie Instrucciones De Instalación

PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this
installation, it is recommended to have the installation completed by a qualified mechanic. If you have any questions, please call our Technical
Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday.
IMPORTANT NOTE: Proper installation is the responsibility of the installer. Improper installation will
void your warranty and may result in poor performance and engine or vehicle damage.
KIT CONTENT:
2 - Valve Cover
2 - Baffle Plate
DESCRIPTION: Edelbrock offers several valve covers for several engine models. See the catalog for
application listing. Installation is the same as original equipment valve covers. All valve covers require that
baffles be installed. Check for clearance between baffles and rocker arms. Trim baffles slightly if necessary.
Edelbrock valve cover gaskets are recommended to ensure a tight seal and perfect fit. Refer to the
table on the right for the recommended gasket part number for your application.
INSTALLATION NOTES FOR ALUMINUM VALVE COVERS:
• Attach the baffles using the supplied screws and blue or red thread locker (thread locker not included).
(See Fig. 1).
Small Block Chevrolet: 1986 and earlier Small block Chevrolet engines with EGR may require #1476 and/or GM #14031368 spacers to
•
provide clearance for the EGR valve, especially with "tall profile" valve covers. Tall covers will not clear mid-70's style manifold mounted air
conditioning brackets.
NOTE: Remember to always check Rocker Arm clearance before fully installing the Valve Covers. A good way to verify clearance is to install
the covers without bolts, then slide them until they make contact. Verify the clearance by checking the offset of valve cover bolt holes with
the head holes. A minimum of 0.060" of clearance is sufficient.
Big Block Chevrolet: Please make sure baffle plate is oriented properly before installing the baffle screws (Fig 2).
•
Small Block Ford: Elite II and Racing Series valve covers are designed to be installed using a short socket and extension on the upper row
•
of bolts. 1/4" drive tools will provide the most clearance.
Catalog: Elite II and Racing Series
Rev. 7/7/15 - QT
®
2 - Breather Grommet
4 - #8 Screw
Fig 1. - Baffle Plate Installation
Make sure to use thread locker or silicon on the threads of the
screws to prevent the screws from coming loose over time.
Fig 2. - Big Block Chevy Baffle Plate Installation
Edelbrock LLC • 2700 California St. • Torrance, CA 90503
Tech-Line: 800-416-8628
Screws Are Flush
With Baffle Plate
1
EDELBROCK VALVE COVERS
ELITE II and RACING SERIES
INSTALLATION INSTRUCTIONS
Edelbrock Valve Cover Gaskets
Engine
Make
Family
Chevy 283-400
Chevy 396-500
Chrysler 383/440
Ford 302-351W
Ford FE
©2015 Edelbrock LLC
Part
Number
7549
7580
7591
7560
7568