Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS
1. Place the coil iron holder into its slot on the base.
2. Set the switch to the OFF position and connect the iron to the
AC outlet.
3. Select the temperature according to your needs (20 W for
circuit boards and 40 W for heavier work).
4. The tip will be hot enough when the solder begin to melt.
After this you can start to solder.
5. Maintain the iron's tip covered with a small amount of solder.
This improves heat transfer.
6. When you finish to use the iron, set the switch to the OFF
position an unplug the iron.
7. To maintain the equipment in peak conditions, remove any
solder residues from the iron's tip once it's cold.
Do not maintain the equipment connected for long periods of
time.
If you require to change the tip of the soldering iron, wait until
it's completely cold, then unscrew and remove the tip. The
replacement tip is model CAU-301.
6
Publicidad
