Netzerotools 7255000 Manual Del Usuario página 8

Step 2. Inspect the LEAP Anchor for physical damage. Look carefully for any signs of cracks, dents or
deformities in the metal. If the anchor has been subjected to fall arrest forces the upright cylinder
will be tipped over to one side. Do not use an anchor that has been subjected to fall arrest forces.
Step 3. Inspect the LEAP Anchor for signs of excessive corrosion.
Step 4. Ensure the condition of the roof will support the LEAP Anchor loads, see section 2.4
5.3 If inspection reveals an unsafe or defective condition, remove the unit from service and destroy, or contact
DBI‑SALA for possible repair.
5.4 USER EQUIPMENT: Inspect each system component or subsystem (i.e. SRL, full body harness, lanyard,
lifeline, etc.) per associated manufacturer's instructions. Refer to manufacturer's instruction supplied with
each system component for inspection procedures.
6.0 MaIntenance, servIce, storage
6.1 The Evolution Counterweight System components require no scheduled maintenance, other than repair or
replacement of items found defective during inspection. See section 5.0. If components become heavily
soiled with grease, paint, or other substances, clean with appropriate cleaning solutions. Do not use caustic
chemicals that could damage system components.
7.0 sPecIFIcatIons
7.1 MATERIALS:
Base Plate: Rubber coated steel
Counterweights: Galvanized cast iron
L-bolts: Steel
7.2 WEIGHT:
Counterweight: 45 lbs.
8.0 terMInology
AUTHORIZED PERSON: A person assigned by the employer to perform duties at a location where the person will
be exposed to a fall hazard (otherwise referred to as "user" for the purpose of these instructions).
RESCUER: Person or persons other than the rescue subject acting to perform an assisted rescue by operation of a
rescue system.
CERTIFIED ANCHORAGE: An anchorage for fall arrest, positioning, restraint, or rescue systems that a qualified
person certifies to be capable of supporting the potential fall forces that could be encountered during a fall
or that meet the criteria for a certified anchorage prescribed in this standard.
QUALIFIED PERSON: A person with a recognized degree or professional certificate and with extensive
knowledge, training, and experience in the fall protection and rescue field who is capable of designing,
analyzing, evaluating and specifying fall protection and rescue systems to the extent required by this
standard.
COMPETENT PERSON: One who is capable of identifying existing and predictable hazards in the surroundings or
working conditions which are unsanitary, hazardous, or dangerous to employees, and who has authorization
to take prompt corrective measures to eliminate them.
9.0 labelIng
9.1 The following label must be present and fully legible:
netzerotools.com
8
netzerotools.com