Setup And Assembly - Mag-Torch MT455 Guia De Inicio Rapido

1. The hose included is equipped with a 9/16-18 left-handed thread connection fitting that mates with the brass valve of the torch and an
excess flow soft nose POL fitting that mates to your bulk cylinder.
2. Thread the 9/16-18 left-handed hose end onto the torch valve in a counter clockwise direction, tightening it with an 11/16" wrench until
it is properly seated. Thread the excess flow soft nose POL hose end into the cylinder in a counter clockwise rotation, tightening it with a
7/8" wrench until properly seated. Do not over tighten fittings. Do not place undue strain on hose.
3. Slowly open the propane cylinder valve and then slowly open the torch valve. Check all gas fittings by using an approved bubble
solution. If bubbles appear DO NOT attempt to ignite the torch. Re-tighten all fittings and re-test with same solution. If leaks persist have
the torch serviced by a professional servicing company. Close both valves after the leak test is completed.
4. Go to an outdoor open environment with the torch, point the burner head away from any flammable objects and any body part of any
person
5. With the torch valve closed slowly open the propane cylinder valve.
6. Open the torch valve slowly approximately 1/8 to 1/4 of a turn, you should hear gas escaping the burner head. Use a flint spark lighter to
ignite the flame. NEVER use matches or a cigarette lighter to ignite the torch.
7. The torch features a control knob on the valve that is used to open and close the valve. This valve is designed to be fully open while
in use. If the valve is not fully open then the pilot to full flame lever will not function properly. The valve also features a lever that when
depressed against the grip of the handle changes the flame profile from a pilot flame to full flame.
8. If gas flow or flame appears to be restricted, close the propane cylinder valve, allow flame or the propane vapor to bleed off. Wait 30
seconds and repeat steps 4 – 6.
9. The torch should not be used with less than a 20 lb. capacity cylinder.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET CES INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS DE ATENÇÃO E INSTRUÇÕES
200 Old Wilson Bridge Road
Columbus, OH 43085

SETUP AND ASSEMBLY

422262 05/20
MagTorch.com