Publicidad
Terminator
10.
Snap on crimp insulators
13.
Completed splice/tee kit. Make sure latch
mechanism is in the locked position.
Three Cable Layout Tips
1.
Locate bus connection (HPT and FP only) and
cable as shown. Cut end of cable at angle to
aid in piercing grommet. Leave additional
cable for expansion loop.
ZS/ZE
TM
11.
Slide silicone caps over crimp insulators.
14.
To remove cap, lift latch mechanism and
unscrew cap.
2.
Insert three cables into expediter.
INSTALLATION PROCEDURES
12.
Tighten cap securely.
3.
Mount expediter with three cables. Do not
band over cable.
4
Publicidad
