Henn&Hart FL0252 Guia De Inicio Rapido página 3

1
1. Screw Top Post Support Rod (D) into Top Post (C)
and tighten with Wrench (F).
3
3. Insert Large Nut (G) into Center Post (E) by hand and
then screw in Support Rod (H) into Large Nut (G).
Tighten all firmly with Wrench (F).
5
5. Insert Post (J) through Base (Q). Secure with
Washer (L), Locking Washer (M), and Small Nut
(N) as shown. Tighten firmly with Tool (P).
2
2. Pull Support Rod (D) out of Center Post (E) about 10 mm,
and partially attach Large Nut (G) by hand.
4
4. Screw Post Connector (J) onto Center Post Support Rod
(H) and tighten firmly with Wrench (F). Slide (H) and (J)
down through Bottom Post (K). Connect Posts (E) and (K).
6
6. Slide top of Lampshade (B) onto Lampshade
Screw (A) and turn Lampshade Screw firmly by
hand to secure Lampshade.
3