Declaration Of Conformity - GYS 057753 Traducción De Las Instrucciones Originales

Pulidora ángular

página de 15

/ 15
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Translation of the original instructions

• The connection between this filter-regulator-lubricator assembly and the tool is done via an compressed air line made of rubber or PVC with a

maximum length of 10 metres and an internal diameter of at least 8 mm for tools with a 1/4» supply connection and 12 mm for 3/8» connections. It

must be equipped with an automatic or semi-automatic closing connection close to the tool, for easy disconnection.

APPLICATION

This tool is specifically designed to grind sharp surfaces, edges or corners, soften or polish metal parts. Any other use of this tool

is strongly discouraged.

DISC REPLACEMENT

1. Disconnect the angle grinder from the air supply

2. Press the side button to lock the disc rotation

3. While holding the button down, unscrew the screw that holds the disc in place with a hexagonal wrench.

4. After placing the new disc in its place, block the rotation of the disc as before. Center the shim over the disc hole and screw in the screw that holds

the disc.

Abrasives heat up during use. Allow them to cool before seizing them. Only use accessories in perfect condition that correspond to the cha-

racteristics of the tool.

ADJUSTMENT OF THE DISC PROTECTION

1. Disconnect the angle grinder from the air supply

2. Press the push-piece above the disc, and rotate the protection as required.

3. Never completely remove the disc cover.

MAINTENANCE

• At the beginning of the day and before a prolonged period of no use, pour a few drops of specialist oil directly into the hole. Do not use flammable

liquids such as gasoline and diesel.

• Regularly check the condition of the regulating filter and the oil level in the lubricator of the air system.

• Ensure that the supply connections, piping and accessories are in perfect condition. Regularly drain the compressor pipes and tank. Keep the limit

date in mind.

• Only original parts available from the supplier may be used for tool maintenance.

• The company JBDC cannot be held responsible for changes made to the tools and non-compliance with general safety rules relating to the use of

compressed air.

TECHNICAL FEATURES

Disc diameter

Rotational speed

(mm)

(t/min)

100

14 000

WARRANTY

The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).

The warranty does not cover:

• Transit damage.

• Normal wear of parts (eg. : cables, clamps, etc..).

• Damages due to misuse (power supply error, dropping of equipment, disassembling).

• Environment related failures (pollution, rust, dust).

In case of failure, return the unit to your distributor together with:

- The proof of purchase (receipt etc ...)

- A description of the fault reported