Vonyx CDJ500 Manual De Instrucciones página 6

16. In
This mode sets the beginning of the loop.
17. Out
This mode sets the ending of the loop.
18. Reloop
This button is used to start the last saved loop. To finish loop, press again.
19. USB
Choose with this button if you will play from USB device or CD.
20. Input Channel A
Selects which source will be live to that channel based on what you have connected to the rear panel input section. In
CD position the internal CD units are active.
21. Input Channel B
Selects which source will be live to that channel based on what you have connected to the rear panel input section. In
CD position the internal CD units are active.
22. Sync
Press button to pair your BT device with the player.
23. MIC Level
Adjust microphone level
24. Master level
Adjust master level output.
25. Cue Level
Adjust cue level
26. Low
Adjust equalization of low frequencies.
27. Mid
Adjust equalization of mid frequencies.
28. High
Adjust equalization of high frequencies.
29. Fader Channel A
Controls individual level of channel A.
30. VU meter
Indicates the master output level.
31. Fader Channel B
Controls individual level of channel B.
32. Crossfader
Achieves clean segues between the two input channels. Hard left selects channel A.Hard right selects channel B.With
the crossfader centered, both assigned channels are live. Use the crossfader for fast and seamless segues from one
selected channel to the other.
33. CD Tray
The disc tray is where the CD is held during loading (Do not force the cd tray to close. Excessive force will damage the
cd mechanism, use the open and close buttons)
34. Microphone Input
Plug 6.35mm Jack (1/4") microphone plug in here
35. Cue Level
Adjust Cue volume.
36. Headphone input
Use to connect for audio monitoring with headphones.
37. Power input
Plug in the included power cord
38. Power On/Off
Press the power switch to turn on or off.
39. GND
Grounding lug for turntable connection.
40. Line/phono input switch
Use this to allow either line level or phono level equipment to be plugged into your channel inputs when phono input is
selected, your signal is fed directly to the high-quality RIAA phono pre-amplifiers. Line level sources will overload the
sensitive phono pre-amps and will sound very bad, so always be sure to toggle the line/phono switch over to line
before connection of line sources.
41. RCA input
Plug in the line level device such as tape deck or additional CD player here.
42. Stereo main output
Unbalanced connectors controlled by the master fader.
6