Setting The Time - koban KOBAMATIC Manual De Instrucciones

KOBAMATIC
Daily Plug-In Mechanical Timer
Specifications
Alimentación
Capacidad
Temperatura de funcionamiento
Maniobra mínima
Modo de programación
Precisión
Setting the On/Off periods
This timer can be used to set up to 48 On/Off periods a day.
Using your finger, a pen or screwdriver pull up all the segments that
correspond to the required "Off" period. For the required "On" period,
make sure the segments are pushed down.
Each segment represents 15 minutes: 4 segments=1 hour

Setting the time

Turn the dial clockwise ( as per indicating arrows ) until the arrow-located at
the top right of the center dial is pointing to the correct time. Ensure that the
manual override switch on the top of the unit is set to the
Connection
Once the required On/Off periods and time have been set, plug the Timer
into the wall socket, and then the appliance plug into the Timer. Ensure that
you then turn the wall socket and the appliance on.
The Timer will now start to operate and switch on and off according to where
the segments are in the up and down position.
Instructions manual |
230V CA, 50Hz
16A carga resistiva
0 - 55°C
15 minutos
Diaria
± 5 minutos
4
position.
www.grupotemper.com