Custom Settings - Marshalltown Bullet 920 I-20-PC Manual De Instrucciones

Backstroke Stop – To cut approved products
over 3/4" / 19mm thick, loosen Phillips head
screw on the Backstroke Stop; turn the
Backstroke Stop 180º and tighten screw.
For more convenience when cutting thinner
products, restore factory setting.
Cutting Depth – You may need to adjust the height of the
blade to cut all the way through your product. You can do
this by:
Adjusting The Stop Screw
1. Loosen the stop screw nut and turn stop screw until it is
loose. Release handle to open blade.
2. Push the handle down until the blade is resting on the
"blade stop"
3. Adjust the stop screw until it contacts the power
assembly.
Laser Realignment
See page 6, step 6.
8 of 18
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

CUSTOM SETTINGS

The Anvil – The anvil has two edges: a
1/32" (0.75mm) narrow edge and a 3/16"
(4.5mm) wide edge. Either edge can be
used according to the support needed
to make a clean cut (some soft-backed
products require the wider anvil edge).
To Change Between Anvil Edges –
Simply remove the anvil screws and flip
the anvil over. Ensure blade stop is in
place.
WS2645