1
2
3
D
4
E
Lock Washer
(4 used in this step)
3. For nice looking, plug 2 Tenon Attachments (E) onto the countersunk holes of the Legs (B) respectively,
as show above. Tap lightly with a rubber mallet if needed.
4. Insert the M8 x 30 mm Wood Dowels (4) into the non-threaded holes on the top of the Legs (B) as a
guide. Position the Mounting Rails (D) onto the inserted Wood Dowels (4) on the Legs (B) ensuring the
side countersunk holes face inward. Securely tighten the Mounting Rails (D) in place with four M6 x 50
mm Bolts (1) and four Washers (2 and 3), using the provided hex wrench.
Assembly Instructions
1
2
3
D
4
B
②
C
M6 x 50 mm
Bolt
(4 used in this step)
Large Flat Washer
(4 used in this step)
③
5
1
2
3
D
4
D
B
①
M8 x 30 mm Wood Dowel
(4 used in this step)
1
2
3
4
E
④