Product Maintenance - Fellowes POWERSHRED 49C Manual De Instrucciones

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Plug in and put
NOTE: Shredder runs briefly
disconnect power
after each pass to clear entry.
switch in ON (I) position
Continuous operation beyond
5 minutes will trigger a
30-minute cool down period.

PRODUCT MAINTENANCE

OILING SHREDDER
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1 2
Set to Reverse Alternate slowly back and forth
( ) for 2-3
seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
2
Set to Auto-On ( )
Safety Lock prevents accidental operation.
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Set to Off ( )
3 4
Set to Off ( )
and unplug
4
3
Feed paper/card
When finished
straight into paper
shredding set to
entry and release
OFF ( )
To set, wait for shredding to stop, push black button down and slide towards front of shredder.
3
Set to Reverse ( )
* Apply oil
for 2-3 seconds
across entry
5 6
Gently pull uncut Set to Auto-On (
and resume shredding
paper from paper
entry. Plug in.
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain
service under this warranty, please contact us or your dealer.
)
3