Caster Installation - Uline FELLOWES SB-99Ci Manual De Instrucciones

• Operation, maintenance and service requirements
are covered in these instructions. Read completely
before operating shredder.
• Keep away from children and pets. Keep hands
away from paper entry. Always set to OFF (O) or
unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters top
opening, switch to Reverse (
• Do not use aerosol products, petroleum-based or
aerosol lubricants on or near shredder. Do not use
canned air or air dusters on shredder. Vapors from
propellants and petroleum-based lubricants may
combust causing serious injury.
• Do not use if damaged or defective. Do not
disassemble shredder. Do not place near or over
heat source or water.
• This shredder has a disconnect power switch that must
be in the ON (I) position to operate the shredder. In
case of emergency, move switch to OFF (O) position.
This action will stop shredder immediately.
• Avoid touching exposed cutting blades under
shredder head.
• Shredder must be plugged into a properly
grounded wall outlet of the voltage and amperage
designated on the label. The grounded outlet or
socket must be installed near the equipment and
easily accessible. Energy convertors, transformers or
extension cords should not be used with this product.
• Fire hazard – do not shred greeting cards with sound
chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
1. Locate casters.
PAGE 2 OF 15
) to back out object.

CASTER INSTALLATION

2. Lay shredder
on its back.
SAFETY
WARNING! Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed in accordance with the instructions,
may cause harmful interference to radio
communications. However, There is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
3. Insert casters
into housing.
4. Flip upright.
0521 IH-2607