Maintenance And Storage; Never Leave A Fan; Unattended While; Operating Or While - Protemp PT-36-BDF-A Manual De Usuario E Instrucciones De Funcionamiento

1. Remove screws from Rear Guard and tilt wheel
(figure 2).
2. Loosen motor nuts, and motor safeguards (located
above and below motor).
figure 2: Removing Guard
1. Inspect your fan before each use. Check all wires and
extension cords, following the procedure outlined on
Page 2 (Safety Information).
figure 4: Capacitor Assembly
© 2015, Pinnacle Products International, Inc.
Belt Tightening / Replacement

Maintenance and Storage

4
3. Remove belt to replace, or adjust motor to tighten belt
(figure 3).
figure 3: Adjusting Fan Belt
2. After use, always be sure fan's Power Switch is in the
OFF position before unplugging. Use cord wrap (see
page 6 Item #7) to keep cord off the ground when
transporting fan.
Bearings
figure 5: Fan Shaft Assembly
Portable Air Circulator User's Manual

NEVER LEAVE A FAN

UNATTENDED WHILE

OPERATING OR WHILE

CONNECTED TO A POWER

SOURCE

Bearing E-clips