Remote Control - GE AKLK08 Manual Del Propietario Y Instrucciones De Instalación

Controls
Features and appearance will vary.
Lights beside the touch pads on the air conditioner control panel
indicate the selected settings.
1 7 9
Air Conditioner Controls
1. Power Pad
Turns air conditioner on and off. When turned on, the
display will show the set temperature.
2. Display
Shows the room temperature or time remaining on the
Delay timer. Shows the Set temperature while setting
the temperature in Cool, Dry or Eco modes.
can be set in Cool, Dry and Eco mode.
4. Mode Pad
or Eco mode.
5. Fan Speed Pad
In Cool or Eco
Auto, High, Med or Low on the unit.
In Fan Only
Med, or Low on the unit.
6. Timer Pad (set by remote control only)
Timer ON — When the air conditioner is off, it can be
set to automatically come on in 0.5 to 24 hours at its
previous mode and fan settings.
Timer OFF — When the air conditioner is on, it can be
set to automatically turn off in 0.5 to 24 hours.
How to set:
Press the Timer pad on the remote control. Each
touch of the pads on the remote control will set
the timer intervals.
To review the remaining time on the Timer, press the
Timer
on the remote control to set a new time if desired.
To cancel the timer, press
control until the set time is zero or press the Timer for
3 seconds.
49-5000524 Rev. 0
8 2
3
Fan Only, Cool, Dry
High,
pads
pad on the remote
4 5
7. Sleep Pad
The SLEEP mode sets the unit to gradually change
increased energy efficiency during sleep hours.
The SLEEP mode is available only in COOL and FAN
only settings.
Press the SLEEP mode pad and its light will illuminate.
The fan indicator will stay at the same setting but
the air conditioner will automatically change the FAN
speed to low in either COOL or FAN only mode.
In FAN only mode, the fan will stay in the LOW speed
will resume the settings that were in place before the
SLEEP mode pad was pressed.
In COOL mode, the fan will stay in the LOW speed
was pressed. The air conditioner will also raise the set
point 2°F in 30 minutes and 2°F more in another 30
that were in place before the SLEEP mode pad was
pressed.
While the unit is in SLEEP mode, pressing any pad will
return it to the settings that were in place before the
SLEEP mode pad was pressed.
8. Filter Reset Pad
This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
240 hours of operation. Clean the air filter (refer to
page 6), place it back in the front panel, and press the
Filter Reset pad. The light will go off.
9. WiFi Connect Pad
Enables connection of the air conditioner to the home
WiFi. Download App for details at:
10. Turbo Pad
Sets the unit to run in cool mode at the lowest temp
setting with high fan speed for 1 hour.
11. Eco Pad (set by the remote control only)
Sets the air conditioner specifically to Eco Mode.

Remote Control

1
3
6
10
11
10
SLEEP mode pad
.
4
5
7
5