Cover Assembly - McCulloch 966805002 Manual Del Dueño

INSTALLING BELT COVERS
1. Place the deck belt shield on the deck over the
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
the deck belt shield and the other end over the end
of the outer pulley cover.
4. Secure with knob.
Belt
Cover
Tab
Outer Pulley Cover
Deck Belt Shield
CHUTE SUPPORT
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two 3/8" holes
into bagger hood.
Upper Chute Support
ASSEMBLY
3. Secure upper chute support to hood with hex bolts,
washers and nyloc nuts.
Retainer

COVER ASSEMBLY

NOTE: For ease of assembly, you may wish
assistance from another person for mounting the cover
assembly to mower.
1. Lift and rotate cover to align the cover brackets with
support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
Flex Trim
7