Operation Manual; Turning Off - Sunwood Marino Guía Del Usuario E Instalación

OPERATION MANUAL

FOLLOW THESE STEPS WITH THE ILLUSTRATIONS AT THE BACK
You operate the fire place with the gas control valve. You can find this valve behind the product's
door.
Turning on
STEP 1
Push the control knob and
turn to the ignition position.
You will hear a click sound
which is the spark to turn on
the pilot burner.
Adjusting the flames
STEP 1
You can set the flames to the
desired position by turning
the Flame Height Button.

Turning off

You turn the fireplace off by turning the control knob back to the same position as the image.
WARNING - WHAT TO DO WHEN YOU SMELL GASS
In the event of gas leakage, the appliance shall not be used or if alight, the gas supply
shall be shut off and the appliance shall be investigated and rectified before it is used
again. If necessary request your dealer for assistance.
When checking the appliance for leakage a soap solution should be applied directly on
all connections/fittings to pin point the exact location of the leak.
Do not use the appliance again until all leaks are resolved.
WARNING
Check the hose at least once a month and every time you change the gas cylinder. If
the hose contains any damage, it will need to be changed by a hose of the same length
and quality.
12
STEP 2
When the pilot burner is
on keep the control knob
depressed for approximately
10 seconds. Then let go.
STEP 2
Turn clock wise to set the fire
to a lower position.
STEP 3
Repeat step one and two
until the pilot burner does
not go off when letting go of
the button.
STEP 3
Turn counter clock wise
to set the fire to a higher
position.