SelectBlinds ROMAN SHADES Guia De Instalacion

INSTALLATION GUIDE
ROMAN SHADES
LIFT SYSTEM: MOTORIZATION
The difficulty level of this installation is ranked at Level 2. You got this!
If you have questions or get stuck, call our Customer Care Team at 888-257-1840, or email customercare@selectblinds.com
INSTALLATION
BRACKET* 1-CHANNEL REMOTE
PENCIL
TAPE MEASURE
1. MOUNTING THE SHADE
INSIDE MOUNT
NOTE: There are no brackets used for inside mount. Use the pre-drilled holes in the top of
the headrail as a guide for your screw placement.
1. Grab the headrail, and hold it up inside the top of the window. Set it back until the front
of the shade is flush with the wall, and make sure it's centered. While holding the shade
material above the headrail, mark through each hole with your pencil.
2. Pre-drill holes at each mark with a 5/64" drill bit, then use the 2" installation screws to
mount the headrail directly to the top of the window.
OUTSIDE MOUNT
NOTE: Use the pre-drilled holes in the top of the headrail as a guide
for your bracket placement. Depending on the size and weight of your
shade, you may need an extra set of hands to help you.
1. Center and hold the headrail at least two inches above the window.
While keeping the shade level, make a small line with your pencil
just above each of the pre-drilled holes in the headrail. Set the shade
aside.
2. Align the top edge of a bracket along each mark, and use the holes
in the back of the bracket to mark where your two screws will go.
®
Simple. Smart. Custom.
HARDWARE AND PARTS INCLUDED
1 2 3 4 5 6
6-CHANNEL REMOTE
* The quantity of brackets you receive will depend on the width of your roman shade.
TOOLS REQUIRED
PHILLIPS SCREWDRIVER
LEVEL
INSTALLATION GUIDE | ROMAN SHADES
BATTERY
16-CHANNEL REMOTE CHARGER
5/64" DRILL BIT
PHILLIPS DRILL BIT
1/4" NUT DRIVER BIT POWER DRILL
Simple. Smart. Custom.
(2")
(1 1/4")
(3/4")
INSTALLATION
SCREWS
STEP LADDER
2" - 4"
UPDATED SEPTEMBER 2020
®
1