Publicidad

Enlaces rápidos

Assembly Instructions
175W
Bistro
Barstool
Congratulations!
This fine piece of furniture will make a handsome
addition to your home. For the best results, start by
reading both the Assembly Instructions and
Finishing Hints before you begin your project.
For normal household use only.
recommended for commercial use.
Do not climb or stand on this piece of
furniture.
174W
Bistro
Counterstool
P.O. Box 2827
Eugene, OR 97402 USA
Service Policy:
parts which are defective, missing or
damaged during assembly. Please contact
Whittier Wood Products customer service
department directly (by phone, fax, mail or
email) for replacement parts.
Hours:
Our friendly customer service staff
can be reached Monday-Friday 7:00 a.m. to
5:00 p.m. (Pacific Time). A message can be
left 24 hours a day, 7 days a week.
To Order:
Provide the complete furniture
model number, part letter, production code,
quantity needed, reason for replacement
and your full name and address along with
a telephone number in case we need to
contact you.
Parts ship from our Eugene, Oregon factory
within 1 or 2 business days from the time
we receive the request. Please allow 5-10
business days for delivery.
Outside U.S. or Canada: 541-687-0213
Outside U.S. or Canada: 541-687-0213
Fax: 541-687-2060 • Email: info@whittierwood.com
Fax: 541-687-2060 • Email: info@whittierwood.com
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Read both the Assembly Instructions and Finishing
Hints completely before beginning.
Store the parts: 1) in their box; 2) in a dry place; 3) in
temperatures ranging from 40° to 90°. (Not on a cold,
possibly damp, cement floor.)
Inspect your furniture periodically for any loose glue
joints or screws, or any other problem which may
be affecting the stability of your furniture. Tighten or
repair as needed.
Production Code:
We will replace any
Rev. 3/06

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Whittier Wood Products Bistro 174W

  • Página 1 Service Policy: We will replace any parts which are defective, missing or Counterstool damaged during assembly. Please contact Whittier Wood Products customer service department directly (by phone, fax, mail or email) for replacement parts. Hours: Our friendly customer service staff can be reached Monday-Friday 7:00 a.m.
  • Página 2 174W Counterstool & 175W Barstool — Parts List Before beginning assembly, check that the quantities of the parts received match those on the parts list below. A — Back-Top — Qty. 1 J — Seat — Qty. 1 C — Back-Bottom — Qty. 1 K —...
  • Página 3: Parts Diagram

    174W Counterstool & 175W Barstool — Parts List (cont.) S — 1¼" Black Screw — Qty. 8 R — 2 " Black Screw — Qty. 8 T — Wooden Button — Qty. 6 U — Lower Side Stretcher (14 ") — Qty. 2 PARTS DIAGRAM Right Front Leg Front Stretcher...
  • Página 4: Tools Required

    174W Bistro Counterstool & 175W Bistro Barstool ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: Phillips Head Screwdriver, Wood Glue, Rubber Mallet or Padded Hammer. IMPORTANT: READ GLUING HINTS BEFORE ASSEMBLING! Not intended for use by children without adult supervision. SHOULDER FIG. 1 FIG. 2 1) Lay out the Back-Top (A), Back-Bottom (C), and Back Stretcher (D) in their approximate positions between the Left Back Leg (E) and the Right Back Leg (F).
  • Página 5 Square end FIG. 3 Angled end 3) Glue two Dowels (P) in each end of the Front Apron (G) and the Side Aprons (H). Lay the aprons on the bottom of the Seat (J) in their approximate positions. See FIGURE 3. Note: The Front Apron (G) is square on both ends.
  • Página 6 FIG. 6 7) Lay the Seat (J) face down on a clean protected surface, with the back of the seat hanging over the edge. Center the leg assembly on the seat and making sure that the seat remains in contact with the back legs, fasten in place with 2¾"...
  • Página 7: Instrucciones Para Armar

    Instrucciones para Armar 174W Banqueta Bistro Normas para obtener servicio: Reemplaza- remos las piezas que tengan defectos, falten o se 175W dañen durante el armado. Sírvase comunicarse con el departamento de servicio al cliente de Whittier Wood Products directamente (por teléfono, fax, Banqueta para correo o e-mail) para obtener piezas de repuesto.
  • Página 8: Herramientas Necesarias

    174W y 175W – INSTRUCCIONES PARA ARMAR HERRAMIENTAS NECESARIAS: Destornillador Phillips, mazo de caucho o martillo, pegamento. IMPORTANTE: FIG. 4 — dowel holes = orificios para las espigas de unión Glue all dowels = Pegue con pegamento ¡LEA LOS CONSEJOS SOBRE ENCOLADO todos los taquetes ANTES DE ARMAR! No son para uso de niños sin supervisión de adultos.
  • Página 9 Instructions de Montage 174W Tabouret de comptoir Politique de service : Nous remplacerons toutes de Bistro les pièces défectueuses, manquantes ou endom- magées pendant le montage. Veuillez contacter directement le service clientèle de Whittier Wood 175W Products (par téléphone, fax, courrier ou e-mail) pour obtenir les pièces de remplacement.
  • Página 10: Outils Nécessaires

    174W et 175W – INSTRUCTIONS D’ASSEMBLAGE OUTILS NÉCESSAIRES : Tournevis cruciforme, maillet en caoutchoue ou marteau, colle. FIG. 4 IMPORTANT : Side stretcher hole = Trou de la traverse latérale AVANT DE PROCÉDER À L’ASSEMBLAGE, Dowel holes = Trous de goujons LISEZ LES CONSEILS DE COLLAGE ! Glue all dowels = Collez toutes les chevilles Non prévu pour usage par des enfants sans surveillance.

Este manual también es adecuado para:

Bistro 175w

Tabla de contenido