Publicidad
Idiomas disponibles
Idiomas disponibles
THESE INSTRUCTIONS SHOULD NOT BE FAXED OR REPRODUCED ON A DIGITAL COPIER. AMERICAN WOODMARK CORPORATION PROVIDES THESE INSTRUCTIONS ON AN "AS IS" BASIS AND DISCLAIMS ANY AND
ALL LIABILITY FOR ANY INACCURACIES, OMISSIONS OR TYPOGRAPHICAL ERRORS CAUSED BY ANY THIRD PARTY'S EQUIPMENT. When you use these instructions, you are consenting to be bound by the provisions
in this paragraph. These instructions provide an illustrative method for installing American Woodmark Corporation ("AWC") cabinets and/or accessories. AWC's instructions are not intended to address every possible
contingency that might be encountered during installation or to endorse the use of any particular tools. AWC HEREBY EXPRESSLY DISCLAIMS ALL LIABILITY FOR ANY CLAIMS FOR INJURY OR DEATH RELATED TO OR
BASED UPON THE USE OF THESE INSTALLATION INSTRUCTIONS AND ANY INSTALLATION INSTRUCTIONS OTHERWISE PROVIDED BY AWC.
Installation Instructions
ROTD DIVIDER KIT (ROTD12 and ROTD15)
This kit is used to mount Roll Out Tray
Dividers into ROTD12 and ROTD15
Drawers.
Contents
• ROTD Divider
• Front Divider Channel
• Rear Divider Channel
• (4) M5 x 15 Screws Wood Screws
Tools Needed
• Phillips Screwdriver
• Safety Glasses
SPECS. GUIDES. DETAILS.
Procedure
Remove the ROTD Drawer
1
from the cabinet if
necessary.
Align the Front and Rear
2
Channels over the pre-
drilled holes located in the
front and back of the Roll
Out Tray Divider Drawer as
shown in Figure 1.
Secure Channels with (2)
3
Figure 1
M5 x 15 Screws into each
Channel. Be sure not to
over tighten the screws to
prevent the screws from
stripping.
Slide the ROTD Divider into
4
place as shown in Figure 2.
Slide the ROTD Drawer into
5
the cabinet. Your ROTD
Drawer is now ready for
use.
Figure 2
Figure 3
Read carefully before you begin installation
M5 x 15 Scew (4 Required)
Rear Channel
ROTD Drawer
Front Channel
ROTD Divider
ROTD Drawer
VS-33 8/07
Publicidad
