Standalone Mode - Laipac LooK Watch J525K Guia De Inicio Rapido

Prepare and charge your device before use.
Charge the battery before using it for the first time or when it sits
unused for extended periods. Warning: Use only charging
devices and batteries approved by Laipac. Laipac accessories are
designed for your device to maximize battery life. Using other
accessories may invalidate your warranty and may cause
damage.
1. Connect the micro USB cable to the wall plug then
connect the other end of the USB cable to the clamshell
adaptor.
2. Plug the USB charger head into an electric socket.
3. Place the LooK Watch on the clamshell adaptor to
match with the charging contacts.
When you connect the LooK Watch to charge, and the device is
off, wait for 10 seconds then press the Power/Back button once
to check the battery level % on the screen.
Battery Charging Tips and Precautions
If the battery is completely discharged, the LooK Watch will not be turned on in 10 seconds after
being connected to the charger. Allow a depleted battery to charge for a few minutes before
pressing the Power/Back button to check the battery level or press and hold to turn on the LooK
Watch. If you use multiple apps at once, the battery will drain quickly. To avoid losing power
during a data transfer, always use the apps after fully charged the battery.
Using a power source from computer's USB may result in a slower charging speed due to a lower
current circuit. The same happens if charging the LooK Watch with multiple chargers connected to
the same electrical outlet.
The LooK Watch can be used while it is charging, but it may take longer to charge the battery fully.
If the LooK Watch is connected to an unstable power source, the display may not function, if this
happens, disconnect the LooK Watch and use more stable power source.
Wear the LooK Watch
Open the buckle and place the strap on your wrist. Fit the strap to your wrist, insert the pin into a hole
and secure the buckle to close it. The wristband is not exchangeable due to embedded antennas inside.

Standalone Mode

You do not need to pair LooK Watch to a smartphone in order to use it. You can insert SIM card (Nano) to
make and receive calls and messages and access internet with a voice and data plan.
Connect the LooK Watch to a smartphone
To connect your LooK Watch to a smartphone, go to Settings > Connect, then select Bluetooth and turn
on the Bluetooth to search for your phone. Also turn on Bluetooth of your phone and search for LooK for
pairing. Once the pairing is done, you can sync your contact of your phone to your LooK Watch. You can
send and receive messages using the downloaded Contact list. It is compatible with smartphone devices
running Android 5.0+ or iOS 8.0+. Connection methods and screenshots may vary depending on your
phone and software version, also depending on your region, service provider, and device manufacturer.
www.laipac.com
8