How to apply
• Before attaching this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly attached.
• The steps below show how to use the product when you are experiencing pain in the outer side of your right knee.
Follow the same steps for the left leg or when you are experiencing pain in the inner side of your knee.
1.
With the Zamst logo positioned under your knee, slide
the product so that the curved edge of the lower pile
loops is positioned 1 cm away from your patella.
Position of patella
Logo mark
2.
Straighten your knee and pull hook-and-loop fasteners A
and B.
Hook-and-loop
fastener B
Hook-and-loop
fastener A
3.
Tighten and fasten hook-and-loop fastener A so that
appropriate compression is obtained.
Hook-and-loop
fastener A
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
1 cm (0.4 inches)
Lower pile loops
4.
Tighten and fasten hook-and-loop fastener B so that
appropriate compression is obtained.
Hook-and-loop
fastener B
5.
While readjusting the compression of the strap, adjust
the part that supports the back of your knee so that it is
aligned with the center of the back of your knee.
The product correctly fastened
Knee support for the right leg applied to the right leg
(If you are experiencing pain in the outside of your right knee)
6.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.