harmonix WX1 Modo De Empleo página 4

WX1-Hex 10/06/05 17:38 Uhr
Refer to fig. 1 on page 3:
1 ON/MUTE/OFF: This slide switch
provides three positions:
ON: Power to the transmitter is on.
M: The signal delivered by the micro-
phone is muted while power and the
RF carrier frequency remain on. This
prevents the receiver from respond-
ing to interference from other trans-
mitters.
OFF: Power to the transmitter is off.
4
Seite 4
2 Status LED: Indicates battery status.
LED flashes momentarily
switching ON and extinguishes: the
battery is OK.
LED lights constantly: the battery will
be dead in about 60 minutes.
3 Input Gain: This rotary pot sets the
sensitivity (gain) of the transmitter's
audio section.
4 Battery compartment for one 1.5-V
AAA size battery (supplied).
5 Carrier frequency label: Lists the
upon carrier frequency band and the carri-
er frequency in MHz of your transmit-
ter. You will also find these data on
the transmitter packaging and in the
Manual Supplement.
3 Setting Up
3.1 Inserting/Replacing and Testing
the Battery
Fig. 2: Inserting the battery.
WX1